Travel Salt/Pepper Shaker

Travel Salt/Pepper Shaker

Boost
9
13
8

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
4.0(1)

Open in Bambu Studio
Boost
9
13
8
0
31
21
Released

Comment & Rating (8)

Please fill in your opinion
(0/5000)

Wouldn't recomend as the salt will get moist and unusable. And then follows the health hazard it (the salt) can scrub of small microplastics and then if you eat it it can scrach your organs, poke in your throat etc.
The designer has replied
1
Reply
It's meant only for short trips where you just need a little salt, do you think it'd still get wet with the screw on cap
0
Reply
Replying to @user_4187384474 :
@user_4187384474 Yes, it will. I tried testing how well 3d print keeps water in (same as water or moisture out). The pot which had an 3 line outer wall 2 line inner wall + 2 or 3 mm of infill lost 1/4 of it's water in like few hours. And no it did not evaporate, some was left in the infill part and some was on a puddle under the pot.
1
Reply
Replying to @haralds.re :
How long was the test
0
Reply
I would advise everyone trying to print this, to print it only in FOOD-SAFE materials, and not just plain PLA. We already have too much micro-plastics in our bodies
1
Reply
EXACTLY!
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.