This cutter with cap was designed to hold a single piece from an 18mm snap-off cutting blades, such as this one:

https://www.homedepot.ca/product/olfa-18mm-snap-off-replacement-blades-10-pack/1000103362

After 'snapping-off' a blade, gently place it into the 'Cutter.STL' end squarely, then while holding the Cutter securely, the the blade against some sacrificial piece of wood or plastic.

The 'Cutter Cap.STL' can be safely put on by first laying the tip of the blade inside the cap from the top or bottom of the clipping part, then gently pressing the Cutter up into the Cutter Cap arms.

Feel free to remix for difference sizes!

'Cutter_LowerGrip.STL' was added because sometimes the blade had trouble being pushed in. If you have issues, this one work better.

DO NOT PRINT WITH SUPPORTS

ALWAYS BE CAREFUL HANDLING SHARP THINGS.

Prusa

No

200