IF YOU KNOW THAT THESE WORK WITH OTHER PRINTERS, PLEASE COMMENT AND I WILL UPDATE THE DESCRIPTION!

Noise and vibration damper feet for your Prusa that install just like those silly little rubber ones in the kits! These bad-boys will absorb high-range frequencies, making your printer a little quieter and stopping a lot of vibrations from traveling into the surface it is sitting on!

Because the back half of the printer is heavier than the front, the back ones are 1mm thicker and provide a slightly higher spring constant. These will work with any printer that has ~8mm channel slots, such as those on the i3 MK3S.

Back piece is labelled with a 'B'
Front piece is labelled with an 'F'

Side 2 works with both front and back.

You'll need to print
2x Back
2x Front
4x Side2

Easiest to install as shown in the photos, where you install the tabbed pieces first, then slip Side 2 into place for the front and back.

Prusa

No

.3