Helmet Hanger Mount

Helmet Hanger Mount

Boost
43
105
5

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1

0.2mm layer, 2 walls, 10% infill
0.2mm layer, 2 walls, 10% infill
Designer
3.6 h
1 plate

Open in Bambu Studio
Boost
43
105
5
4
75
9
Released

Description

I couldn't find a helmet mount which I enjoyed so I used my fillament mount which I already uploaded adn created thes knob thingy.
It works great for me and you can print it without support. I printed it with 10% infill, other than that, Bambu Lab standard settings.

Enjoy :)

Comment & Rating (5)

Please fill in your opinion
(0/5000)

Boosted
Good work, I like it
The designer has replied
Show original
0
Reply
Danke dir!
0
Reply
Danke!!!
0
Reply
Boosted
Thanks Piet! I’m going to print two of these to hold my bike helmets once I receive a high temp resistance filament, nice simple clean design. I think the only way to make it simipler is to put the screws within the tube, so that they are hidden. Which should be easy since the top already screws on and off! Do you mind if I try that and upload a remix if I’m successful? I may have to use bigger screws to make it stable, or one larger screw right in the middle.
(Edited)
The designer has replied
0
Reply
Thank you very much and enjoy them :) What I like about the design is, thank you can change the purpose of the hangers. For example, my filament holders have the same base plate.
0
Reply
No more