Improved Version - Wukong Mech - The Great Sage, Equal of Heaven

Some details have been added, the holes for feeding filament have been removed, the tolerances have been adjusted, and the assembly difficulty has been reduced.

There are two bodies inside the armor, one for the version with a cloak, and one for the version with a battle flag. You can choose one when printing.

The skeleton has two sets of shoulder armor that connect to the skeleton, the shorter one is for the version with the cloak, the longer one is for the version with the battle flag. You can choose one when printing.

The cloak is printed with TPU filament, if you do not have TPU filament, you can print the version with the battle flag.

The feathers are best printed with TPU filament, other filaments can also be used if you don't have TPU. After printing, you can use a lighter to shape them. When installing the feathers, you can use a filament thread to enlarge the holes a bit.

No supports are needed for printing, and no glue or hardware is required for assembly.

See the third and fourth images below for assembly.

The skeleton is best printed with ASA filament, it gives the best results, of course, other materials can be used as a substitute. The armor doesn't matter, any material is fine.
Due to the influence of the printer and filament, some parts of the armor and skeleton may be very tight. You can adjust the print tolerance of the armor, or use brute force.
Douyin: Gongyu Mech (EXIA); Xiaohongshu: Gongyu Mech (Qingdu).

I hope you will all support me, thank you.