This modeling is based on the Fan Duct from MK4S and remixed for Ender3 V3 SE.
It is dimensioned to the Gdstimes 5020 Blower Fan, and it can be assembled utilizing SE stock screws.
BOM
Gdstimes 5020 Blower Fan 24V × 1
Cable with JST 1.25 Terminal × 1
Print Profile
Material: ABS or PETG
Layer Height: 0.2mm
Infill: Cubic 20%
Support: No Support Required
Fan tower has set the Bridge Speed to 10mm/s and you can expect to see visible performance.
The cable terminals should be replaced with JST 1.25 and it is recommended to extend them with a cable with terminal.
And the total length of the cable is recommended to be 200mm, which can be fixed to the cable holder on the model.
Thanks to Josef Prusa.
Comment & Rating (2)