Poop Chute cover for Ultimate Nozzle wiper Remixed by gongzila

Remixed by

gongzila

3D Printer>3D Printer Parts

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 4 walls, 25% infill

Designer

27 min

1 plate

4.7(14)

Upside down with tree supports - 0.12mm layer, 2 walls

35 min

1 plate

4.9(20)

Open in Bambu Studio

Boost

185

291

176

Released

Description

After 2 consecutive multi color print fail due to purge clogged and nock out the nozzle cover, I then try to find some solution and try out “poop chute system” by lars.komm. too bad I had the nozzle wiper upgraded with “ultimate nozzle wiper” by Technerd which have extra thickness from the tube. I try to trim out both tube and the cover but it still too tight so I create a new model that have enough space to fit with the ultimate nozzle wiper.

Comment & Rating (49)

@tanwk3

it's a nice design. keep poop out of the plates. but be careful if it start to clog like this, need to clear it will the chute will be clogged up

@vprasad

what build plate is that?

@tanwk3

Replying to @vprasad :

that from BIQU

@vprasad

Replying to @tanwk3 :

you mean the cryogrip one?

@RBCreations

I printed this with PETG-CF and PETG keeps clumping right here. is that just because they are the same material?

The designer has replied

@gongzila

I'm not sure about that but I don't think so. What I did when there are too many of this happen was rotate the silicone tube a bit so that the cutting line move aside and uncut tube is the one wiping the nozzle directly. sometime when the cutting line of the silicone tube just in between the nozzle path, it just grab the ooze and got stuck there instead.

@RBCreations

Replying to @gongzila :

Thanks I'll try that

@michaoderso

Boosted

Simple print and great add-on for my P1S.

@TommyCederlund

Print Profile

0.2mm layer, 4 walls, 25% infill

great

@Dasvidanya24

Print Profile

0.2mm layer, 4 walls, 25% infill

very good!

@HumanPeopleInc

Boosted

Print Profile

Upside down with tree supports - 0.12mm layer, 2 walls

Haven’t tested it yet but it fits nice and printed well.

@Gabriel_77

Print Profile

Upside down with tree supports - 0.12mm layer, 2 walls

Thank you!

@TommyCederlund

Print Profile

Upside down with tree supports - 0.12mm layer, 2 walls

fine

@user_825668203

Print Profile

Upside down with tree supports - 0.12mm layer, 2 walls

Aside from the somewhat unsightly support connections, everything else is excellent

Show original

@alenknight

it's great, but i feel you should note that the orientation of the print profile is wrong and needs to be flipped. by default, your 3mf files has it printing the way it's installed... with the flat big space up top... with no supports. running this from my phone was a mistake. easy print and works great... but a lot of folks print from phone and without even a word of caution.... this can cause headaches.

The designer has replied