Marvin's Bambu AMS Cardboard Spool Rim

Marvin's Bambu AMS Cardboard Spool Rim

Boost
6
8
3

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 100% infill
0.2mm layer, 2 walls, 100% infill
Designer
19 min
1 plate
5.0(1)

Open in Bambu Studio
Boost
6
8
3
1
15
10
Released

Description

I tried some other cardboard spool rims here but they suck - they slip off too easily. I designed one with a lip to greatly reduce the odds of the rim slipping off while printing. Tested on ELEGOO Rapid PETG and PLA+ cardboard spools (which are 199mm diameter) and this rim works great!

 

This should work with any ~200mm cardboard spools (there is some tolerance built-in) where the cardboard sides are approximately 3mm or less in thickness. I also uploaded the original Fusion 3D f3d file, so you can adjust the parameters to change the various dimensions of the rim, if you need to do that to make it fit your spools better.

 

Prints without supports.

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 100% infill
The designer has replied
0
Reply
Curious - why 4 stars? What can I do to make it 5? :-)
0
Reply
Replying to @mherbold :
my bad..I thought it printed different ring size...but it turned out the filament roll was warped.. otherwise it was a great print...five stars mate 👌
0
Reply
No more