Bambu Filament Swatch Holder Tower

Bambu Filament Swatch Holder Tower

Boost
84
195
23

Print Profile(1)

All
A1
P1S
P1P
X1 Carbon
X1E
X1

0.16mm layer, 2 walls, 15% infill
0.16mm layer, 2 walls, 15% infill
Designer
7.7 h
3 plates
4.6(12)

Open in Bambu Studio
Boost
84
195
23
14
128
76
Released

Description

A new version of this previous model:

 

https://makerworld.com/en/models/663894#profileId-591190

 

I added a base so you can keep your sample tower on your desk. The filament sample holders are the same of previos project.

 

Boost Me (for free)

If you like this project, please give a 👍 and help me reach more makers like you!
Your support means everything! You can give me a 🚀, publish your remix creations and finally leave me a review. Thank you so much!

 

 

Good print!

Comment & Rating (23)

Please fill in your opinion
(0/5000)

Boosted
The print came out great. But, I’m a little confused and need help. On the long pieces that you hang the swatches on - is there supposed to be indents for the small pegs? Please see the picture - is it supposed to be smooth? Thank you.
The designer has replied
1
Reply
Yes, there are a holes for pegs. In the print I have enabled the supports. You need to remove them.
0
Reply
Boosted
Replying to @_the_mechanic_ :
I'm not only sure what you mean - what supports? There doesn't seem to be any supports. Just that the spot where the holes appear to be needed is solid. Thank you for the quick response.
1
Reply
Replying to @JNiece :
I assure you that those are supports. Try to pull them off mechanically or try to reprint the piece.
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
looks great and super handy to get them out
The designer has replied
0
Reply
Thank you so much for your support!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
turned out awesome! the swatches fit in perfect. Wonderful addition to my machine
The designer has replied
0
Reply
I'm proud of this project! Thank you very much for your support!
0
Reply
Replying to @_the_mechanic_ :
You should be very proud of this project! It works amazingly well and looks awesome!
0
Reply
This is by far my favorite swatch tower to date. :)
The designer has replied
0
Reply
Thank you very much!!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
too tight for the swatches
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you for support me!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.