Xbox Controller Stand for IKEA SKÅDIS Pegboard

Remixed by

Xbox Controller Stand for IKEA SKÅDIS Pegboard

Remixed by
Boost
70
147
27

Print Profile(2)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 4 walls, 15% infill
0.2mm layer, 4 walls, 15% infill
Designer
2.4 h
1 plate
4.9(13)

Rectilinear infill, adaptive layer height and less infill
Rectilinear infill, adaptive layer height and less infill
1.7 h
1 plate
4.6(10)

Open in Bambu Studio
Boost
70
147
27
32
260
159
Released

Description

I've designed a minimalistic Xbox Controller Stand for the IKEA SKÅDIS pegboard

 

Video

 

Subscribe or follow me on:

Instagram: https://www.instagram.com/agepbiz/
YouTube: https://www.youtube.com/user/agepbiz
Twitter: https://twitter.com/agepbiz

Comment & Rating (27)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 4 walls, 15% infill
Great
0
Reply
Boosted
a perfect fit. Thank you.
0
Reply
Print Profile
Rectilinear infill, adaptive layer height and less infill
Prints without issues
0
Reply
Print Profile
Rectilinear infill, adaptive layer height and less infill
Looks amazing in Bambu PLA black matte 👍
Show original
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 15% infill
The area where the controller sits is a bit rough. This is by design as this part of the model. I would assume this is either from a 3d scan which was used to model the print or to increase the grip of the controller on the print. Prints great in eSun PLA+ using standard settings.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
printed out good, clips good fit. thankyou
0
Reply
Boosted
By far the best one on MakerWorld.
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 15% infill
Beautiful
0
Reply
Boosted
Print Profile
Rectilinear infill, adaptive layer height and less infill
Other Issues:The adaptive layer height let to unusual artifacts on the print. The model itself is great. I printed it again using a standard profile after this failed print and that came out perfect. I would therefore propose to use a other profile.
The designer has replied
0
Reply
Boosted
Those artifacts are extrusion issues and not a property of my profile. Did you calibrate your fillament, is the fillament properly dry and of good quality? Not nice to rate my profile low because of it.
4
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply