Catapult Angle Change

Catapult Angle Change

Boost
34
58
5

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
13 min
1 plate
5.0(3)

Open in Bambu Studio
Boost
34
58
5
7
81
19
Released

Description

This super quick print is an easy way to retrofit the existing model to have a higher angle shot.

 

Installation:

Slide the angle changer over the existing M shaped stopper. If it will not go on, flip it the other way and slide it down that way.

Comment & Rating (5)

Please fill in your opinion
(0/5000)

the original has a share-alike attribution clause. you shouldn't use SDFL on it.
0
Reply
Have seen this in action, it is a beast
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very helpful Just a bit fiddly to assemble
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.