Adapter Rings for 250g Filament Spools for Bambu Lab X1-Carbon AMS (140-154mm diameter) Remixed by mediaman3d

Remixed by

mediaman3d

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 16% infill

Designer

1.8 h

1 plate

4.4(47)

0.6mm nozzle, 0.2mm layer, 2 walls, 16% infill

Designer

1.6 h

1 plate

4.5(2)

Open in Bambu Studio

Boost

195

507

397

Released

Description

Eryone spools are a different size (150mm diameter), so I modified the original design in a couple of ways. This should work for any filament spool that is 148-152mm in diameter and up to 4.5mm thick rim.

Resized for 150mm spools and the thickness of the spool sides (4.5mm).
Added 5m width spacer to each side ring to better fit in AMS (Amolen spools are very narrow).
Modified retainer clips to make it easier to install. Clips are specific to each slot in the ring.

Print 2 rings and 6 clips.

Print instructions

The attached 3MF file was created in BambuStudio.

Print the spool adapter x2, clips x6.

Assembly

Images also show the assembly process. Place the spool between the helper nubs in the adapter. Then from the inside of the spool, from the rim side, insert at three places the clips so it grabs the rim of the 250g spool and the inner part of the printed adapter. The clips are unique to each slot, they should snap in place.

Repeat this for the other side of the spool.

Make sure any irregularities from printing are removed from the outer rim of the spool extender.

Usage

Place the extended spool in the AMS spool slot, in the center. Roll the spool back and forth to make sure the rolling goes smoothly. Then feed filament in the AMS and use as normal.

UPDATE 12-16-2022: Added support for Stronghold and AMOLEN 250g spools.

Comment & Rating (58)

@user_1588090840

Print Profile

0.2mm layer, 2 walls, 16% infill

This is perfect for small 250g silk spools so that they can fit in the AMS.

Show original

@Dirtay

what brand

@julianfj

Print Profile

0.6mm nozzle, 0.2mm layer, 2 walls, 16% infill

perfecto pasra las bobinas de eryone

@DANIEL3D.SE

Print Profile

0.2mm layer, 2 walls, 16% infill

@user_1613768611

Print Profile

0.2mm layer, 2 walls, 16% infill

works great. not sure why there are so many clips? looks like I have double the amount needed to attach the spool

@Dirtay

I believe from reading the info. Some of the clips are for different spool brands

@Boxil01

Print Profile

0.2mm layer, 2 walls, 16% infill

Very sloppy fit on Amolen spools. Not going to even try it in AMS since nothing is tight.

@Dirtay

Definitely, agreed. i tryed this with amolen filament will not work

@user_2305785042

teh clips did not hold the reel firmly and I can't see how it could work with the ams.

@bowmanshannon

Print Profile

0.2mm layer, 2 walls, 16% infill

The first one prints fine then the problem starts the second one you have to change nozzle

@user_3036058478

the 2 plates are for 2 different nozzles for a reason, for one tiny spool you need to print just 1 plate 2 times (take the clips off the print before starting the 2nd one)