Raptor 3 Engine (CrazyJ) Real Hardware Remix

Remixed by
Copyright Claim

Raptor 3 Engine (CrazyJ) Real Hardware Remix

Remixed by
Boost
8
12
0

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.16mm layer, 2 walls, 5% infill
0.16mm layer, 2 walls, 5% infill
Designer
2.3 h
2 plates

Open in Bambu Studio
Boost
8
12
0
0
16
6
Released

Description

 

This is a real hardware remix for CrazyJ's Raptor 3 Rocket Engine Model.

The parts remixed so far include:

 

Upper Engine (1)

Upper Engine (2)

 

REQUIRED OR SUGGESTED HARDWARE:

 

 

Taps: 1.8mm and 2mm Tap

Grub Screws: 35 - 2x4mm

Screws: 12 - 3x10mm

Nuts: 12 - 3mm (choose your favorite, Nylon Insert lock nuts may be visually more appealing)

For Upper Engine (1) -

 

The part that will use the 35 grub screws- I suggest running a 1.8mm tap through the bottom of every hole. Then, run the 2mm tap afterward. Be patient, be careful. These walls are thin, and if you try to skip steps or force something the walls will more than likely snap.

 

 

For Upper Engine (2) -

-This one is self explanatory. Get creative: Use whatever color bolts/screws/nuts you like. You can use regular nuts like I did (just used these because I have a ton laying around) - Or you can opt for a better looking nut: Perhaps a Nylon Insert lock nut.



Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more

This remix is based on

This source model was used for remixing/sharing before its license was restricted.
SpaceX Raptor 3 Rocket Engine

License

This user content is licensed under a
Creative Commons Attribution-Noncommercial