This case was designed for when I moved my Anycubic printer over from Marlin to Klipper firmware, and I needed somewhere to hold my Raspberry Pi Zero 2, which was ideally close to the printer.

This design is composed of a simple RPI Zero 2 case, along with a mounting bracket which can be used to secure the case to a v-slot rail on a 3D printer.

Parts List:
1 x Shell Front
1 x Shell Back
1 x V-Slot Guide
2 x 8mm/10mm M2.5 Screws
2 x 14mm M2.5 Screws (or two more 8mm/10mm if you don't to mount it to the V-Slot Guide)