Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 400x200mm in size
You may print at higher layer heights below the Min Depth of 0.96mm
The Max Depth is 2.7mm and the Actual Depth is 2.6mm

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Silver Transmission Distance: 0.5
PLA PolyLite White Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4
This print uses 5 unique filaments

Swap Instructions:
Start with Black
At layer #13 (1.12mm) swap to Blue Gray
At layer #16 (1.36mm) swap to Silver
At layer #18 (1.52mm) swap to White
At layer #22 (1.84mm) swap to Red for the rest.

Also, in my photo I posted I had my prints in a frame that is on Canadian Gamer @CanadianGamer page