👇New Tilt Phone Stand V4.1 - MagSafe 👇

Finally the new version of my tilt stand is here🥳! The stand is modified based on your reviews to version V3.0.

• The main change is the wireless charger included with the Kit-K012. This innovation allows the stand to be used as a tilt dock station.

• Added side lighting. When charging, the side LED lighting turns on automatically ⚡. When the phone is removed from the stand, the LED turns off.

  

• The bottom cover of the charging cable has been added. A cable cover has been added for better handling of the stand. In the previous version V3.0 it happened that the cable lifted the stand - this has been fixed.🤩

  

• The model is designed for minimal supports. I recommend using my print profile!

  

• Furthermore, the popular design as in previous versions has been preserved! Also, the arreting screw was retained to prevent tilting of the stand (lock position).

👉Assembly instruction 

Video Tutorial 👉 

1. You will need Kit-K012 which includes Circuit Board & Coil, Wire LED Light 10 PCS, Connecting Wire (Long), Power Splitter Board 2PCS and M2x5 6PCS screws. (M2x6 4PCS and M2x5 2PCS can be used). The stand can of course be used without this equipment, but it won't be as cool 😂.
2. Place the Circuit Board on the 01_Stand and fix with 2PCS M2x5. (NO M2x6!).

3. Stick the charging coil on the 01_Stand. Stick the coil based on your mobile!

   

4. Place the LED on the 06_SideBar as shown below 👇 Push the cables from the LED through the slot in 01_Stand. Then connect the cables using the Power Splitter Board. Then use the Connecting Wire to connect the Power Splitter Board to the Circuit Board.

   

5. Place 07_Cover with M2x5 (or M2x6) 4PCS. Then assemble the rest of the stand and you're done! 🥳🥳

NOTE: If your LED fell out of the 06_SideBar, use a lighter to heat and melt the top of the pin👇