Drill holder (wall mount)

Drill holder (wall mount)

Boost
30
94
7

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E

Drill Holder 1-13, 0.2mm layer, 2 walls, 15% infill
Drill Holder 1-13, 0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
1 plate
5.0(7)

Open in Bambu Studio
Boost
30
94
7
6
85
48
Released

Description

I was looking for something to mount the metal drills on our workshop wall. Nothing I found quite matched what I had in mind so I ended up making one myself.

The holes all have a 0.4mm tolerance (except for the 1m drill, that's at 0.6mm tolerance) and sink in 20mm deep. It's enough to hold the drills just fine while still leaving some space to mount it by just using the two screw holes in the lower half.

We used Spax 4x45 screws to do the job as the holder itself has a 35mm depth.

It will fit drills from 1 to 13 in 0.5 increments.

Comment & Rating (7)

Please fill in your opinion
(0/5000)

Print Profile
Drill Holder 1-13, 0.2mm layer, 2 walls, 15% infill
looks nice and compact. I look forward to mount it. Thanks for the nice and minimal design- saves space on my wall:-)
1
Reply
Print Profile
Drill Holder 1-13, 0.2mm layer, 2 walls, 15% infill
Exactly what I wanted Thank you
Show original
1
Reply
Print Profile
Drill Holder 1-13, 0.2mm layer, 2 walls, 15% infill
2 walls might be a little too weak for this one, it started cracking when I secured it to the wall with screws. If it breaks further I'll reprint it a bit stronger.
1
Reply
Print Profile
Drill Holder 1-13, 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Drill Holder 1-13, 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Drill Holder 1-13, 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Drill Holder 1-13, 0.2mm layer, 2 walls, 15% infill
0
Reply
No more