Desktop Tablet Stand - Desk Organizer Remixed by Peter MartinMakerWorld: Download Free 3D Models

Remixed by

Peter Martin

Household>Office

IP Report

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

H2D

0.2mm layer, 3 walls, 10% infill

Designer

12.9 h

4 plates

4.8(13)

V1 base no logo, V2 top. 0.2mm layer, 3 walls, 10% infill

7.5 h

3 plates

Open in Bambu Studio

Boost

110

142

Released

Description

Desktop Tablet Stand - Updated December 2024

Trying to declutter my desk so reworked my existing model :-

Keyboard or Tablet Stand - Adjustable Tilt by Peter Martin - MakerWorld

The desktop tablet stand now holds three Pens, a Ruler and has charging cable routing built in.

I've also created a plain base and a Hex design base with just the charging access as options if you prefer a cleaner look.

All parts, although different, are compatible with the previous version, so if you just want the new Base Unit, it will work with your existing print.

The Range :-

Comment & Rating (17)

@Kaspink

Boosted

Print Profile

0.2mm layer, 3 walls, 10% infill

Excellent. As you can see I am using it for my white board, which works well as I needed a solid backing to be able to write on it when it is upright on a slant. I also love the pen holder, my only minor complaint is that the pens fall off a lot, perhaps a little deeper of a slot. That is also another of your designs in the picture that I use for painting models and ornaments etc. Love that one too!

The profile uploader has replied

@PMMzero

Thank you. Glad to see you've found a novel use for it. If I get chance over the next couple of days I will alter the base to hold the pens in better. If you have any further suggestions let me know as I will be working on the model anyways. I will let you know when its uploaded. Thanks for the boost too.

@PMMzero

I have just uploaded an improved base that holds the pens in better if you wish to download it.

@user_2577423778

Boosted

Print Profile

0.2mm layer, 3 walls, 10% infill

Printed perfectly, used your top v2 with the cable management clips and the v1 bottom stand. I removed your logo by the way for a cleaner esthetic. Works great alongside my remix of your great phone stand!

@Lilex_

Boosted

Print Profile

0.2mm layer, 3 walls, 10% infill

works perfectly 👍

@user_1613501498

Boosted

Print Profile

0.2mm layer, 3 walls, 10% infill

Works perfectly!

@OlliNutter

Boosted

Superb model, clean files. Printed without issue. In short, excellent

Show original

@RNJCK

Print Profile

0.2mm layer, 3 walls, 10% infill

The overall print was excellent other than running out of filament before I could finish. I was sure how I could change colors and resume print. Sure to maintain stock of same colors. Will try again so I can rate better than 3 stars.