Stacking Resource Holders for Everdell board game

Remixed by
Copyright Claim

Stacking Resource Holders for Everdell board game

Remixed by
Boost
89
302
26

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.16mm layer, arachne walls, 15% infill (bottom only)
0.16mm layer, arachne walls, 15% infill (bottom only)
Designer
6.6 h
1 plate
4.9(17)

Open in Bambu Studio
Boost
89
302
26
42
249
158
Released

Description

This is a remix of a remix of the original model created by justjerms1971 over at Thingiverse (remixed by Drimascus).

Walnut shaped resource holders for the board game Everdell. I modified them so that they could stack inside each and take up less room. They are 108%, 100%, 92% and 84% and they hold all the resources for the game, just put the twigs in the largest one (credit to Otilia_dk for the idea).

Can also be used for any nature themed game, just print as many as you need. I've used them for Earth and Maple Valley as well.

Comment & Rating (26)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.16mm layer, arachne walls, 15% infill (bottom only)
Works and looks great. Also fits perfectly in the box unlike some of the other designs. Good job! :)
The designer has replied
1
Reply
Thanks, glad you like them and thanks for the boost!
0
Reply
Boosted
Print Profile
0.16mm layer, arachne walls, 15% infill (bottom only)
Nice, look great in the game 👍
The designer has replied
1
Reply
Thanks, glad you like them!
0
Reply
Print Profile
0.16mm layer, arachne walls, 15% infill (bottom only)
1
Reply
so useful
The designer has replied
1
Reply
Glad you like them and thanks for the boost!
0
Reply
Looks great!
The designer has replied
1
Reply
Thanks so much for the boost!
0
Reply
Love It
The designer has replied
1
Reply
Thanks so much for the boost!
0
Reply
Boosted
Print Profile
0.16mm layer, arachne walls, 15% infill (bottom only)
Printed pretty well. Even using Bambu PLA on a new printer, it had some minor layer issues. The need for supports is not a plus and leaves them a bit rough underneath, but with the natural look this is going for, I'm not sure that was avoidable.
The designer has replied
1
Reply
Thanks so much for the boost! Yeah, when I print these on slower printers, the supports are not needed. It's just the high speed ones that require supports in those areas, due to the layers not being able to cool in time. So if you want to print them without supports, just print them slow.
0
Reply
Print Profile
0.16mm layer, arachne walls, 15% infill (bottom only)
very cool print add a cool aesthetic to the game.
1
Reply
Print Profile
0.16mm layer, arachne walls, 15% infill (bottom only)
1
Reply
Print Profile
0.16mm layer, arachne walls, 15% infill (bottom only)
1
Reply