This Filament Clip is the perfect accessory to keep your 3D printing filament organized and tangle-free. Designed to snap onto your filament spool, it securely holds the loose end of the filament in place, preventing unwinding during storage or transport. It also prevents your spool from rolling around so it doubles as a spool stand.

The Clip has three differently sized holes to give you the best possible fit for your filament. The smallest hole starts at 2mm and every circle is 0.1mm bigger than the previous one. The middle hole should fit most filaments best. I've also added a variant with 5 holes also starting at 2mm and increasing by 0.1mm to support a wider variety of printing tolerances.

Please note that the tolerances are quite tight so for the first couple of times using it, it might be tough to put the clip on the spool.