Portable monitor stand by mkerhat

mkerhat

Tools>Gadgets

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.15mm layer, 2 walls, 15% infill

Designer

2.9 h

2 plates

5.0(3)

Open in Bambu Studio

Boost

Released

Description

I use it to fix my Arzopa 17,3" portable monitor, but you can use it for any portable device. there is a filament string inside of the hinges. Just melt the end with lighter.

Comment & Rating (5)

@alirslinger

Boosted

Print Profile

0.15mm layer, 2 walls, 15% infill

I printed this in Tinmorry CF-PETG on my A1. I had to drill out the holes so the piece of filament would slide through. Strong , stable & portable as a verticle monitor stand. My laptop has thunderbolt so this monitor gets power and display from one usb-c cable. The stand folds up and enables me to throw my entire office, that runs on two cables if you include the power brick, into a backpack. In conclusion - this is a true 5 star portable monitor stand. It’s exactly what you wanted. ❤️

The designer has replied

@mkerhat

many thanks for your positive rating. the hole diameter is over 2mm, so it should not be necessary to drill the holes, but I will extend it a bit and upload updated version.

@alirslinger

Boosted

It was too hard to push through for me, so I drilled it. Could be the fibrous material I used. That filament isn’t tuned either.

(Edited)