Easy clean toothbrush holder with replacable tray by pearigee

pearigee

Household>Other House Models

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

7.4 h

5 plates

4.9(35)

Full PETG set - 0.2mm layer, 2 walls, 15% infill

4.1 h

1 plate

Open in Bambu Studio

Boost

567

919

1.3 k

593

Released

Description

Ever get tired of dirty toothbrush cups? Me too!

I wanted to design a simple toothbrush holder where the base could be removed or replaced. The whole model is super easy to print and assemble.

Assembly guide

Slide the arched holder into the base.

2. Place the grate on top of the tray.

3. Slide the grate/tray into the base!

Comment & Rating (55)

@pbauwens

Nice! I remodeled it for a single toothbrush.

The designer has replied

@pearigee

Nice! You should publish your remix, it’s a great idea!

@pearigee

Replying to @pearigee :

Oh! Just saw that you did here: https://makerworld.com/en/models/626145#profileId-550634 Thanks!

@user_1120712311

sadge

@Lode

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

printed in Bambu PLA matte gray. Came out good, the brim on the base needed some filing.

@user_2055861539

can you print it with the AMS

@visualdensity

Print Profile

0.2mm layer, 2 walls, 15% infill

Lovely design! Almost perfect - the grate hole size is too small for some toothbrush with rounded end of the handle. They just slips right off (look at photo). I use it without the grate and it's bit better but as you can see in the photos, it also seems to slide and don't stay upright. Suggestion: Add some segments in the bottom tray to match the holes so the toothbrush stays in the same section perhaps? Thanks for sharing, much appreciated!