Carrot Balisong (Long model) by NLZBBMakerWorld: Download Free 3D Models

NLZBB

Toys & Games>Other Toys & Games

IP Report

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

By object, regular print, 0.2mm layer, 2 walls, 15% infill

59 min

1 plate

4.7(32)

Both Karot Knafs!

1.5 h

2 plates

5.0(6)

Both sizes for A1 Mini also

1.8 h

2 plates

5.0(2)

Open in Bambu Studio

Boost

172

305

829

256

Released

Description

Content has been automatically translated.

Show original

Hello, if you plan on downloading this model please consider leaving a like, posting a make, leaving a review, or even a donation. Thank You!

Hi There, if you plan on downloading this model please consider leaving a like, posting a make, leaving a review, or even a donation. Thank You!

I have carefully designed all the details of this Carrot Balisong so that you can print this model perfectly without any additional support, but you may need to use 4 M3*6 flathead screws. In which you need to print two "叶子(长)" parts, for a total of three parts. Note: When printing, you may need to pay attention to the printing direction of the "叶子(长)", using the side that does not need support as the bottom surface.

Bill of Materials

Maker’s Supply Kits and Parts

M3x6 半圆头机牙螺丝 (20PCS) - AA057

B-AA057

1.06 USD

× 4

Buy Now

Download BOM

Comment & Rating (43)

@user_840183467

Print Profile

By object, regular print, 0.2mm layer, 2 walls, 15% infill

Just need m3x6mm Could use a more weighted handle, also maybe sand the blade a bit so it doesn't catch on the handle.

@Fritz85

Print Profile

By object, regular print, 0.2mm layer, 2 walls, 15% infill

Super danke.

@Praxis_Diederic

Print Profile

By object, regular print, 0.2mm layer, 2 walls, 15% infill

Very cool and funny! Was a blast to print. Printer in the cheapest, wettest PLA I had laying around and it came out really nice! Thanks for creating it

@REDxGetSchiwfty

Print Profile

By object, regular print, 0.2mm layer, 2 walls, 15% infill

Basically had to make the screw holes bigger on the carrot part. I made them 3.5 mm to fit M3 screws.

@strand520

M3*5 screws I'm not sure if they will fall off

Show original

@crdungan

Thank you! Fast and easy print. I think a corn version would be cool, too! I used Bambu PLA Basic Bambu Green and iSANMATE High Speed Orange PLA+ for my print.

(Edited)