Motocross

Copyright Claim

Motocross

Boost
88
163
11

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 9% infill
0.2mm layer, 2 walls, 9% infill
47.7 h
4 plates
4.3(7)

Open in Bambu Studio
Boost
88
163
11
14
447
128
Released

Comment & Rating (11)

Please fill in your opinion
(0/5000)

Difficult print for sure and had a few of the spokes break off but it surprisingly printed out pretty decent! I only did the small size for one of my kids friends - found a stand on printables website for it to sit on. Thanks for the upload!
The designer has replied
1
Reply
Yes, I know it’s not an easy print, however, it turned out well 😉 Thank you for the comment
Show original
0
Reply
where did you get the stand from?
0
Reply
Print Profile
0.2mm layer, 2 walls, 9% infill
was extremely carful with supports yet a whole tyre snapped off
0
Reply
Print Profile
0.2mm layer, 2 walls, 9% infill
prints well and looks cool
0
Reply
Print Profile
0.2mm layer, 2 walls, 9% infill
Front fork is really brittle and a lot of suports that need so much attention to remove. i love the model a lot, maybe i’ll try the bigger model too
0
Reply
Print Profile
0.2mm layer, 2 walls, 9% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 9% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 9% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 9% infill
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.