Remixed for better printability:

I came across a filament, which I had issues to print this stand with. Particularly I experienced lifting overhangs, which caused the nozzle to crash into them and break the columns.

I was lazy to calibrate the filament properly and instead I changed the radius of the overhangs, so that it is easier to print and less likely to cause issues for everyone.

In the pictures you see also the V2 version (pink) - you can compare and see the change in the arches. The last photo is the complete evolution V1 (gray), V2 (pink) and V3 (red).

The stand was originally made for Harry Potter Funko Pop mini figures from Kinder Joy surprise eggs. These are the same height as Funko Pop keychains and Advent Calendar figures. It is also nice for Disney Doorables figures. However, in its original size the display is too small for brick figures - for these it needs to be scaled up a bit (only the height).

I use poster putty to hold the figures in place.

Print with 0,2 - 0,3 layer, 2-3 walls, no supports.