Large handheld pin art fidget toy by pearigee

pearigee

Toys & Games>Other Toys & Games

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

Designer

7.2 h

1 plate

4.6(59)

Open in Bambu Studio

Boost

1015

1748

2.6 k

942

Released

Description

Note: First layer tolerances are tight! Grab by handle an bang on table to free individual pegs!

Please ensure your print bed is clean before printing! Hope you enjoy it!

After my original version, it was requested on Reddit that I make a larger one! Challenge accepted!

Comment & Rating (76)

@subton

Print Profile

0.2mm layer, 2 walls, 15% infill

Tolerance is VERY tight. I’m still working to release all pins. A1 using Overture Light Blue PLA

The designer has replied

@pearigee

Thanks for the feedback! I will look into releasing a new version with wider tolerances. It’s a tough balance between securing the pegs while printing and easily releasing them after. I printed mine in Voxel PLA+ on an A1 mini. With that setup a few sturdy bangs on my work bench was able to free the pegs.

@subton

Replying to @pearigee :

Yeah. I tried banging mine on the workbench and my wife looked at me and said “what in the world are you doing?!” 🤣

@Badkitty

Replying to @subton :

That's when you say back to her, " I'm 3D printing! What does it look like?" While continuing to bang the part on the bench lol.

@chadam

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed very well. Cool design. Took some time to free up all the pins, but it was well worth it. Thanks for sharing!

The designer has replied

@pearigee

So glad to hear it! Thanks for the comment :)

@xpmn

Print Profile

0.2mm layer, 2 walls, 15% infill

printed with silk filament, some pins broke when released. And releasing them was a pain. I think pins are too tight

Strength Issue:pins are to tight - it's easy to broke them and toy don't work as expeted

@VRsculpts

Boosted

silk filament causes issues on any models with tight tolerances

@herren

Boosted

Like everyone I agree that the tolerances are a li'll high, but slowing down the print speed and printing at 0.2mm helped a lot. Bit of patience is all!

@luro02

Print Profile

0.2mm layer, 2 walls, 15% infill

It works, but some pins are stuck when you remove the plate from an object.

@user_3104343614

smack them on a table to free them

@user_2374277431

Print Profile

0.2mm layer, 2 walls, 15% infill

A few of the pins would not go down no matter how hard I tried, but over all I think it’s a really good print

@TheNeck

Boosted

came out AMAZING, boosted twice!

@user_2813622478

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

amazing model and great print quality. I just had one issue: when I removed the print from the build plate, the pins didn't come out, and I had to use a hammer to make them work