Looks lovelyand gf loves it but had afew issues which could be due to my filament as its a silk pla(pic of the inside) - under the right bow some of the print was ripped off with support so be careful

The model looks good, however, it is advisable to create your own print profile. The model has far too little infill. The support structures are too tightly attached and are difficult to remove. When you try to detach them, it sometimes tears holes in the model because the walls are too thin. All in all, unfortunately not such a beautiful result. I would like to print it again with different settings, but unfortunately I don't have any more material in that color because I wanted to use up the leftovers..

looks amazing, the wife loves it, but sadly the supports stuck way too well and we're extremely hard to remove, ended up causing damage to it, also little defect in the smoothness of the bottom

the supports busted holes in the bow when I removed them and one of the ears didn’t print correctly. I’m newer at printing so there might have been an issue on my end. overall still pretty

Hi, how do I open the file? I can't get any slicer to open it nor did 3mf to stl converter worked.

The supports are difficult or impossible to remove