A1mini side cable guide-guida cavo laterale A1mini by Revenge

Revenge

3D Printer>3D Printer Accessories

IP Report

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

28 min

1 plate

4.8(55)

Open in Bambu Studio

Boost

241

483

371

Released

Description

guide/support for the side cable of the bambulab A1 mini printer without having to use clips to connect it to the ptfe tubes.

for the head thread guide see my page.

https://makerworld.com/en/models/602628#profileId-525084

not good for big sister A1.for that see my page.

printed in petg

guida/supporto per il cavo laterale della stampante bambulab A1 mini senza dover usare le clip per collegarlo ai tubi in ptfe.

per la guida filo della testa vedi la mia pagina.

https://makerworld.com/en/models/602628#profileId-525084

non va bene per la sorella maggiore A1.per quella vedi la mia pagina.

stampato in petg

Comment & Rating (86)

@6xg4vty98s

Print Profile

0.2mm layer, 3 walls, 15% infill

Awesome. Works perfectly.

@Revenge

thanks. but from the photo I see that you should insert it a little more so that it is aligned with the exit of the wire

@6xg4vty98s

Replying to @Revenge :

Yep. You're right. My other machine is printing but it's the same thing. Just needed a little more force!

@Chadgetsbored

Print Profile

0.2mm layer, 3 walls, 15% infill

Came out great put it on the mini - thx

@Revenge

thanks

@grwang41

Print Profile

0.2mm layer, 3 walls, 15% infill

very good

@Revenge

thank you so much

@user_2399944419

Print Profile

0.2mm layer, 3 walls, 15% infill

Superb print with my new A1 mini. Turned out perfectly

Show original

@kukbaPrint11

Print Profile

0.2mm layer, 3 walls, 15% infill

good princ

@morgana.play

Print Profile

0.2mm layer, 3 walls, 15% infill

everything holds up perfectly as I wanted

@Matteotac3d

Print Profile

0.2mm layer, 3 walls, 15% infill

Magnificent, supremely satisfied Thank you

Show original

@House_Elliott

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

fits well and is smaller and lighter than some of the larger cable guides. Printed in PLA Matte

@user_3204752560

Print Profile

0.2mm layer, 3 walls, 15% infill

@Redeye91

Print Profile

0.2mm layer, 3 walls, 15% infill

a bit to big to fit in the A1 mini

@Revenge

Forgive me, a little too large in what sense? If it doesn't fit into the cutter's housing, you likely miscalibrated your filament and printer because it doesn't cause problems for anyone else

Show original

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.