• The original 3mm walls of the TUSH (The Ultimate Spool Holder) were way too thick to fit inside of the generic cereal boxes I had while using a 68mm wide Bambu spool.
• The walls in this remix are 1.4mm, with added reinforcement along the bottom to keep it strong despite the thin walls.
• It's compatible with TUSH++ rails. Since the walls are thinner, it wobbles a little bit on the rails. If this is a problem, the wedges can be used for extra support.

Instructions

• All items can be printed without supports.
• I used a 0.4mm nozzle with 0.2mm layer height on a Bambu P1S.
• Assemble using 4x 608 ball bearings that snap into the pegs.
• The .f3d file is included if you need to change the thickness or if the bearing pegs need to be modified for your printer.