This is a fully experimental filament painting, used green and yellow fluo PLA to make it light while under blacklight.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
- PLA BambuLab Basic Black
- PLA Ziro Translucent Green
- PLA BambuLab Basic BambuLab Green
- PLA Ziro Fluo Lime Green
- PLA Ziro Fluo Yellow
- PLA Ziro Skin
- PLA BambuLab Basic Jade White
Swap Instructions:
- Start with Black
- At layer #10 (0.88mm) swap to Translucent Green
- At layer #24 (2mm) swap to BambuLab Green
- At layer #26 (2.16mm) swap to Lime Green
- At layer #29 (2.4mm) swap to Yellow
- At layer #31 (2.56mm) swap to Skin
- At layer #34 (2.8mm) swap to Jade White for the rest.
Enjoy my work? Support me by joining my club on printables. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.
Comment & Rating (0)