Desk lamp compatible with e14 bulb or bambulab kit 001 (fully printable)

fully printable table lamp. it supports bambulab led kit 001 or you can install an e14 socket.

Hardware is printed in petg (but you can use commercial steel hardware, nuts and bolts are m6)

To install the E14 lamp holder, simply insert the socket into the hole and tighten with the flanges supplied with the lamp holder. then just slide the wire into the appropriate guide in the body of the lamp as you see in the photos

if your lamp holder comes with only one ring, or you lose it, you can print it. here is my file

https://makerworld.com/en/models/590277#profileId-511813

for the bambulab kit you just need to use the supplied adhesive to glue it to the base and slide the cable into the guides

the rest of the assembly is quite intuitive, you just need to insert the lampshade into its guide and glue the ribs into their slots. the rest of the components are secured with nuts and bolts The hole tolerances are quite tight so depending on the filament and print quality they may be too tight for the bolts. I recommend you keep a 6 mm drill bit handy to widen the holes just enough to insert the bolts

if you like it download it