Cascade AirTag MagSafe wallet - Lefty and Righty Remixed by Jerry

Remixed by

Jerry

Fashion>Other Fashion Models

Print Profile(1)

All

X1E

P1S

P1P

X1 Carbon

A1 mini

0.16mm layer, 2 walls, 15% infill

Designer

3.7 h

1 plate

4.9(16)

Open in Bambu Studio

Boost

200

204

Released

Description

Cascading AirTag MagSafe wallet with glides for easier sliding actions. Great for fidgeting too :)

MagSafe ring like this one

Differences from original
Added AirTag holder, MagSafe ring, glides for better lever sliding action, thicker lever, and lever, fan and back button are all printed separately for better appearance. Changed the side relief geometry. Changed the top and bottom geometry for better handling. The cascading mechanism is held together with 1 M3x10 screw and nut. Mirrored for lefty users.

Bill of Materials

Maker’s Supply Kits and Parts

M3x4x10 SHSS Machine Screw (10PCS) - AA209

$0.99 USD

B-AA209

× 1

M3 Carbon Steel Hex Nut (20PCS) - AB005

$1.00 USD

B-AB005

× 1

Buy Now

Download BOM

Comment & Rating (22)

@s5862140

Boosted

Print Profile

0.16mm layer, 2 walls, 15% infill

This is the only model that mounts the AirTag from the inside out, which I think makes it less likely to fall off. The small slide track that reduces the resistance of the slider and the structure of the clip that holds the card are also better designed in this model. The only drawback is that it's a bit of a hassle to mount the AirTag from the inside out.

Show original

@TheBestLurius

Print Profile

0.16mm layer, 2 walls, 15% infill

Printed great. The only problem was that the cut outs on the sides tend to move during layers making a clicking noise. I was sure that the print would fail so I added a piece of tape mod way of the print.

@aronvico

Boosted

Print Profile

0.16mm layer, 2 walls, 15% infill

love it! could't get the magsafe ring work on it but all the other stuff is flawless

@stevecary

Boosted

Can you make another one without the AirTag support? Thanks! Steve

@creep_e

I would also like to see this without the airtag

@LeeBob

Boosted

Replying to @creep_e :

same :)

@stevecary

Boosted

Print Profile

0.16mm layer, 2 walls, 15% infill

Awesome. I have printed most every wallet I can find from several sites and this one is built the best. I love it. Thanks! I used PETG-HF.

@kgusta

Print Profile

0.16mm layer, 2 walls, 15% infill

Love the design, especially the integrated airtag holder. The hinge mechanism seems robust with the M3 screw and nut. I used PLA, perhaps PETG would have been better. Would advise avoiding abrasive materials. The issues I have with this type of wallet is that because it's friction fit, the material and your cards will slowly destroy each other. After one night of sitting with cards inserted sides of the wallet deformed and allowed the middle cards to just fall out.