I used the same photo as Venom VS Spiderman by Remy DiT

my model is 200x200mm and spiderman is in red in this hueforge print

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 1.4mm
The Max Depth is 3.2mm and the Actual Depth is 3.2mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Blue Gray Transmission Distance: 3
    PLA BambuLab Basic Jade White Transmission Distance: 5
    PLA BambuLab Basic Red Transmission Distance: 4
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #19 (1.6mm) swap to Blue Gray
    At layer #20 (1.68mm) swap to Jade White
    At layer #26 (2.16mm) swap to Black
    At layer #32 (2.64mm) swap to Red for the rest.