SCUBA diving bolt-snap hose holder

SCUBA diving bolt-snap hose holder

Boost
29
87
14

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

One of each (0.2mm layer, 4 walls, 15% infill)
One of each (0.2mm layer, 4 walls, 15% infill)
Designer
20 min
1 plate
4.9(9)

Open in Bambu Studio
Boost
29
87
14
15
99
62
Released

Description

Just two simple hose holders for scuba diving. A normal bolt-snap eye or a D-Ring (5mm thickness) goes into the small hole, the holder then snaps onto the hose. The fit on the hose is tight enough to not come lose when you don't want them to, but they can be easily ripped off in an emergency or when entangled.

Give these to that one dive buddy that always has his hoses dangling everywhere or use them yourself if you are that guy. :)

 

v7 fits most miflex and rubber low pressure hoses.

v8 fits miflex high pressure hoses.

 

I've had great success with Prusament PETG, 5 top/bottom layers, 3 perimeters and 20% infill. Should work with almost every filament though. Maybe ASA might be best because of it's UV resistance.

 

Update 2024-09-14: Added six more variations to allow any combination of low pressure and (miflex-) high pressure hoses to be clipped together. With or without bolt snaps.

 

These do not comply with any standard such as EN250 or others, use at your own risk.

Comment & Rating (14)

Please fill in your opinion
(0/5000)

Boosted
It would be wonderful to have an adapter for thicker rubber hoses My Poseidon regulator has a hose diameter of 14 mm A 122% scaling fits well, but the loop for the bolt snap is then somewhat large
The designer has replied
Show original
1
Reply
Check the "Test" folder I just uploaded a version with a 13mm inner diameter for the hose hole Does it fit Or is it too small, too big Are the outer walls thick enough at that point or could they break The thickest rubber hoses I have right now have a diameter of about 127mm, the normal clip with 115mm fits perfectly
Show original
0
Reply
Boosted
Replying to @Duglum :
Perfect fit! Many thanks! Regarding durability, that remains to be seen ;-)
Show original
0
Reply
Boosted
Print Profile
One of each (0.2mm layer, 4 walls, 15% infill)
Excellent model with rounded edges, protecting the tubing
Show original
1
Reply
thanks
1
Reply
Boosted
A very good model :)
Show original
1
Reply
Print Profile
One of each (0.2mm layer, 4 walls, 15% infill)
good
1
Reply
Print Profile
One of each (0.2mm layer, 4 walls, 15% infill)
1
Reply
Print Profile
One of each (0.2mm layer, 4 walls, 15% infill)
1
Reply
Print Profile
One of each (0.2mm layer, 4 walls, 15% infill)
1
Reply
Print Profile
One of each (0.2mm layer, 4 walls, 15% infill)
1
Reply
Print Profile
One of each (0.2mm layer, 4 walls, 15% infill)
1
Reply