Hello!

I was eating an ice cream as I was playing around with a simmilar smaller fidget so the idea came from there :D

The top and bottom part are cut out for smoother fidgeting and easier printing.

Tried printing with a ice ball at the bottom but there isnt enough connection with the build plate and the whole ice cream got tipped over.

This model doesnt need any supports to print!

I allso added a multicolour version but as I do not have an AMS and the appropriate colours for the ice cream ball, i printed it in the single colour.

The colour is shampagne (beige).

You can choose between single plate printing with both parts or double plate with each part on its own.

I would recommend printing just one piece at a time as to eliminate stringing between the 2 parts but if youre using a bambuu and newer filament you should be fine.

Print settings:

• 2 walls
• 15% gyroid infill
• 0.2mm layer height
• no supports

Hope you like the model and happy fidgeting!