The rest of my Cartoon / Manga / Anime Hueforge's can be found here:
https://makerworld.com/@CanadianGamer/collections/1363776

-----------------------------------

The pictured Frame is Version 2 of my friction Fit design for 200x200 Hueforges

https://makerworld.com/en/models/559845#profileId-479071

You may see a floating regions error. You can ignore this error.

In my print profile I have used a height range modifier (HRM), which means that the first 4 layers of the model will print with a 0.16 layer height, and switch to a 0.08 layer height for the details. If you use my uploaded print profile this will save you time on your print as the first 0.64mm is just to provide stability to the print for display. This means that the layer heights listed below in my printing instructions will not match my print profile (they will be off by 3) but the mm heights will still match! Do not change the print profile to match or it will not look the same!

If you resize the model make sure you do NOT scale the Z axis or the print colours will not be in the same position

Printing Instructions

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black
PLA BambuLab Matte Marine Blue
PLA BambuLab Matte Scarlet Red
PLA BambuLab Matte Ivory White

Swap Instructions:
Start with Black
At layer #12 (1.04mm) swap to Marine Blue
At layer #17 (1.44mm) swap to Scarlet Red
At layer #22 (1.84mm) swap to Ivory White for the rest.

----------------------------

A Commercial license to sell printed copies is available on my Patreon:

https://www.patreon.com/CanadianGamer3DPrintsEDM

As part of your membership you will also have access to exclusive files available only on Patreon.

----------------------------