SCREW IT! - Clamp-able vase for shelves ...
SCREW IT! - Clamp-able vase for shelves ...
Boost
119
212
8
Print Profile(5)
RIBBED SCREW IT! VASE - 0.16mm layer, 2 walls, 15% infill
Designer
8.1 h
1 plate
SMOOTH SCREW IT! VASE - 0.16mm layer, 2 walls, 15% infill
Designer
5.5 h
1 plate
FUZZY SKIN SCREW IT VASE - 0.16mm layer, 2 walls, 15% infill
Designer
6.2 h
1 plate
Vase insert - 0.16mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Click to see more
Open in Bambu Studio
Boost
119
212
8
9
55
28
Released
Description
The "SCREW IT!" vase is a fully 3D printable vase that clamps to your shelves or other places, wherever it fits!
You can assemble the vase by following these instructions;
1. Remove support after printing the BODY.
2. Insert SCREW into BODY and screw in at least halfway.
3. Insert HEX ROD into the BOTTOM CAP (should snap / get stuck)
4. Allign HEX ROD in hex side from SCREW.
5. Snap BOTTOM CAP onto BODY.
Now the mechanism should work!
NOTE:
This design is licensed under a Creative Commons Attribution-Noncommercial-Share Alike Please do not sell this file or printed product.
Want a Commercial Licence? Become a member of my Patreon page!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeGet Commercial License
Related Models
Comment & Rating (8)