This is my first 3d model.

I needed a GPU anti-sag support that could span over my bottom mount fans.

Dimensions

• Legs are 10mm deep and 60mm wide.
• Minimum support height is 95mm but you could saw off 10mm from the threaded riser to get that down to 85mm. If you want it shorter, I can add other riser options.
• Maximum support height is 115mm
• Cross bar width is 175mm

Printing

0.2 layers with 15% infill (threaded risers is 25% for a little extra rigity)

Supports

• Support is required for the cross bar
• Support is optional for the threaded riser - i used it just for a cleaner finish
• Support is recommended for the legs, without it the bottom of the thread is a little messy. Print them laying down without support if your OK with one side not looking as nice.