Wizard Bear - Piggy Bank (3 sizes) by ideat0m

ideat0m

Household>Decor

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

Wizard Bear Piggy Bank - 205mm - A1

Designer

9.2 h

2 plates

5.0(1)

Wizard Bear Piggy Bank 250mm - P1P

Designer

25.1 h

2 plates

Wizard Bear 178 mm - A1 mini

Designer

11.3 h

2 plates

Open in Bambu Studio

Boost

Released

Description

With kind permission @xxLASWSxx (Makerworld)
Model Wizard Bear

Wizard Bear Piggy bank in 3 sizes - 178, 205 and 250mm. The model is printed in PLA, I recommend printing the lower part (coin cover) from TPU, but it will also work from PLA.

Comment & Rating (6)

@user_538253318

Boosted

Print Profile

Wizard Bear Piggy Bank - 205mm - A1

With the plug as TPU this print came out great, and my kid loves it. The supports aren't too hard to remove either. With PLA, I could not get the plug to fully fit in. It might work with a rubber mallet or something, but I couldn't get it to work. Designer responded and tried to help trouble shoot, so 5 stars for support as well. I have not tried the new PLA plug that he suggested I try, as my TPU arrived so I used that instead. Nice piggy bank!

(Edited)

The designer has replied

@ideat0m

I remade this bottom part for 205, but when i printed original today, for me TPU normally works, PLA little hard, but also ok. Anyway, i decreased size down to 99% and now must be ok

@user_538253318

Boosted

Replying to @ideat0m :

hmm. that is odd I'm using the x1c with your profile and it does not fit easily. I can get some of it in, and then it feels like I'm either going to break it, or it's going to be so tight it will never be taken out. I can get about half on, and the other half is getting me to push hard enough I worry I may break it.