A deadpool hueforge!

I use AMS lite for the print, only require 4 colors. AMS are not required, but easier for the printing process.

If no AMS, then have to change filament manually, following the description below.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x85.67mm in size
 

Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Matte Scarlet Red Transmission Distance: 2
PLA BambuLab Matte Ivory White Transmission Distance: 3.5
PLA BambuLab Matte Ash Gray Transmission Distance: 1.5
 

Swap Instructions:
Start with Charcoal
At layer #8 (0.72mm) swap to Scarlet Red
At layer #12 (1.04mm) swap to Ivory White
At layer #14 (1.2mm) swap to Charcoal
At layer #19 (1.6mm) swap to Ash Gray
At layer #21 (1.76mm) swap to Ivory White for the rest.

Update!
Ver.2 adding pink filament can make the face part look slightly more three-dimensional.
I use PLA esun Matte Strawberry Red, , and the result looks quite good in practice.

Ver.2 swap Instructions:
    Start with Charcoal
    At layer #8 (0.72mm) swap to Scarlet Red
    At layer #10 (0.88mm) swap to Strawberry Red
    At layer #14 (1.2mm) swap to Charcoal
    At layer #19 (1.6mm) swap to Ash Gray
    At layer #21 (1.76mm) swap to Ivory White for the rest.