Support Issue:the default settings make this print very challenging the parts are small — obviously but some pieces like the pawns are particularly weak at the stem around the base the support material under the bottom is very hard to remove, we printed the pieces 3 times with supports and broke more than half each time trying to remove the material after the 3rd batch, I adjusted the settings to no supports, and those printed just fine. I rec printing with no supports, use a brim for adhesion if needed

Strength Issue:since it was so small it bent really easily and broke, however it was really fun to bring it around. :)

Strength Issue:3 attempts with both pla and petg. it snaps misprint each time.