Love the design and would definitely rate it 5 stars if the following were corrected. Even with a 0.2 nozzle, the writing on the card is still not very clear. As others have mentioned, the wing also has an area that breaks off (I'm not sure if it is because of lack of supports). I glued this wing back on as a simple fix. i actually reprinted, cutting off this part of the wing as well so the card lays flat. Overall this is still a great print.

Print came out really good! I did have the right wing tip fail at the base but just sliced that one little section and glued it on. The supports under the arms were almost impossible to remove but got them eventually. regardless still love how this turned out.

all the file names say Gengar although this is Charizard

the surface of the card is not printing well for me due to all the texture. the words are not readable. could you post a flat version of this. so the words work better. or could you send me the igs so I can fix it?

I attempted this, however the card its self was not legible.

Printed really well! The wing did break off as others had mentioned. Overall a great print though!

Overall good, slightly problematic with the wing part and some details. Nothing that can't be fixed, but requires extra time.

can you make one with cubone?

Very nice design.

make a1 mini compatible