Doll House Flower Wall Art

Doll House Flower Wall Art

Boost
24
56
8

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.16mm layer, 2 walls, 15% infill
0.16mm layer, 2 walls, 15% infill
Designer
32 min
2 plates
5.0(4)

Open in Bambu Studio
Boost
24
56
8
0
24
21
Released

Description

This is a doll house decoration I made for my daughter's Barbie house. There is a base flower that is completely flat and a top flower that curves out. After printing both, I glued them together.

No supports needed. No AMS.

Comment & Rating (8)

(0/5000)

Print Profile
0.16mm layer, 2 walls, 15% infill
Only printed the bottom. Did have a lot of stringing but might be due to my fillament.
0
Reply
I had a little, but not a lot. It was super easy to pull off without it affecting the print quality. If you are experiencing a lot, it could be due to the filament being to wet from the atmosphere or maybe you can adjust your setting overrides in your filament settings to adjust for retraction and z hop to reduce stringing.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
thank you for the review! I'd love to see how it turned out if you have a photo.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Thank you for the review! I would love to see a photo!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Thank you for the review!
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.