Recently, the Philips toothbrushes at home have all had problems, so they have all been replaced with LAIFEI electric toothbrushes. The official did not configure the charging base, and this is a magnetic charging cable. I really like the original author's base, and after printing it, I found that the size is suitable for the LAIFEI aluminum version of the electric toothbrush, which is different from the ABS version I use, and it cannot be charged. So I made a secondary creation based on the original. Although it is called a secondary creation, there are actually quite a few changes.
1. The angle of elevation is canceled. After installing the magnetic line, the toothbrush can be placed very well without the angle of elevation.
2. The overall height and arc shape are reduced, and I personally like this simple appearance.
3. The bottom winding is adjusted, and it can also fit the wall completely when charging.
4. The back storage is adjusted, which allows the extra wire to be stored better.

Tip: To prevent the charging magnetic head from being easily brought out, the size of this hole is made very tight. I printed it with PLA consumables. According to previous experience, PETG has a different shrinkage rate, and printing with PETG may cause the charging magnetic head to be unable to be inserted.