Unique mechanical Nintendo Switch cartridge stand.
No glue or non-printed parts are required. 
Good bed cleaning and adhesion are recommended for small parts. 

Also, check my collection of other Nintendo Switch accessories:

• Nintendo Switch Accessories Collection

Remakes and commercial use are forbidden!

Assembly Guide is attached in the documentation and described below:

Printable parts list:

1. Cartridge carrier x12
2. Left frame
3. Cylinder lid
4. Stopper
5. Bolts
6. Axle
7. Axle clip
8. Main cylinder
9. Axle disc
10. Clicker
11. Handle
12. Right frame
     

Step 1

Insert 12 cartridge carriers into the main cylinder facing Nintendo Switch logo to the right.

Step 2

Cover the main cylinder with the lid. Pay attention to a wider groove position!

Step 3

Insert the right frame into the left one

Step 4

Insert 2 bolts into the respective holes and tighten them (be carrefour, not too tight) using a 6 mm hex bit.

Step 5

Insert the axle into the handle.

Step 6

Put the clicker onto the axle with corresponding side facing top (see the picture)

Step 7

Insert the axle into the frame while holding the main cylinder with the other hand.

Step 8

Put the axle disc on the axle

Step 9

Fix the axle with the axle clip

Step 10

Insert a stopper into the left frame and secure it with the bolt. Adjust the stopper angle so it touches the cartridge carrier.

Step 11

Insert your cartridges

Congratulations! You have finished the assembly!