Cybertruck wireless charger

Revision02 (2024-8-3)

    Optimizations:

1. Provide 2 options:
   1. Basic bambu lab Kit-012 LED components applications (for people who can not get COB LED easily.)
   2. High performance of COB LED light applications (for people who can get COB LED easily)
2. Adjust circuit board position to avoid addition wire soldering. wires in Kit 012 is enough.

3. Use transparent filament for guiding light from LED to head light and tail light area. 

    

   !!! Please note:

1. There is only one model which can be use for 2 options.
2. There are 2 installation instructions. one is for Basic Kit 012 LED version and another is for COB LED version.

------------------------------------------------------------------------------

Revison01-----Original-----July21-2024---------------------

Bambu lab Kit-K012 Applacable only.

see attached “installation instruction.”

Views of model

How to use it.

V4 charger station hold TypeC. plug off and connect to you cybertruck.

push your phone into to start charging.

Head Trunk open and close one cycle.

Tail light is on

head light is on.

You can put your SD card and spare sim card or small tools in the trunk.

You will never lose them again!!!

Please see bleow introduction video.

Attention!!!

Most important thing for the printing:

please keep defulte setting for the 1st plate. and to check if the 2nd layer is same as below. it will be easy to be broken when you folding the modle if it is incorrect line dirrection at the folding area.