Dog Poop Bags Roll Dispenser Remixed by MeetYourMaker

Remixed by

MeetYourMaker

Household>Pets

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

Designer

3.2 h

1 plate

4.9(23)

A1 Mini Version - 0.2mm layer, 2 walls, 15% infill

Designer

3.9 h

1 plate

4.8(12)

0.6mm nozzle, 0.3mm layer, 2 walls, 10% infill, snug support

2.9 h

1 plate

Open in Bambu Studio

Boost

111

336

378

277

Released

Description

This is a remix of With_Maltodextrin's Earth Rated Dog Poop Bags Roll Dispenser. I've created a version with 3mm sliced off the top to ensure printability on the Bambu A1 Mini.

Description

Holds 10 rolls of bags and has screw holes to be wall mounted, or use two sided tape/Command Strips to attach. Bag rolls are about 30mm in diameter and 61mm wide, so this dispenser might work with others. Initially designed without the odd angled surface inside, but before that was added I found that the rolls would get stuck on each other and just "hang", and not roll downwards to be dispensed. The angled surface is supported from below with another angled surface that's steep enough to not need supports. Dog bag rolls are 15 count of 9x13" bags per Amazon's description. There are sacrificial supports built into the model for the opening, so you don't have to fiddle with support settings in your slicer.

Print Instructions

There are 3 sacrificial supports that need to be removed after printing, they'll come right off.

Bill of Materials

Bambu Filaments

Jade White

A00-W1-1.75-1000-SPLFREE

× 1

Buy Now

Download BOM

Comment & Rating (41)

@user_2844372653

Print Profile

0.2mm layer, 2 walls, 15% infill

Rolls get caught a little occasionaly but overall good design and easy print

@MidNorth

Boosted

Print came out great with ERYONE matte green PLA.

@flanker1743

Print Profile

0.2mm layer, 2 walls, 15% infill

Good design but if you overfill it the bag rolls get stuck. May require some fiddling but overall does the job.

@nemalkin

Boosted

Print Profile

A1 Mini Version - 0.2mm layer, 2 walls, 15% infill

I have used this for a few months and it works near flawlessly. Nice way to keep extra rolls of doo bag handy.

The designer has replied

@MeetYourMaker

Thank you for the kind comment and boost, enjoy!

@Noodjuice

When hanging on the wall, I found the screws make it hard to squeeze the bags through the channel, might be worth making the holes higher or lower

The designer has replied

@MeetYourMaker

Thanks for the feedback! Mind sharing a picture to show what you mean?

@Noodjuice

Replying to @MeetYourMaker :

Sure! Usually the rolls slip straight through but once we hung it up, the screws block it a little... You can still push them through but it's not as smooth as before