This is a painting, transformed into a filament painting using Hueforge.
If you scale it, don't change the height of the image.

Printing notes:

This image is 6 colors. I used my P1S and 1 AMS. When the final layer of the 4th color swap is getting near, I have added a “pause” in the g-code:

This gave me the chance to swap out black and light blue filament in my AMS with grey and white. When I hit “resume” it will print 1 more layer of yellow, followed by grey from slot 1 and followed by white from slot 2.
You don't need an AMS to print this, but it makes it a lot easier. If you have 2 AMS units you would of course remove the “pause” and the same goes for you guys without AMS.

Also remember that the filament setting I use in the following profile is calibrated to the brand i use. If you use different brands or material, you should adjust accordingly

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Esun Space Blue Transmission Distance: 3.5
PLA+ Sunlu Red Transmission Distance: 6
PLA+ eSUN Yellow Transmission Distance: 5
PLA+ Sunlu Grey Transmission Distance: 2
PLA BambuLab Matte Ivory White Transmission Distance: 4

Swap Instructions:
Start with Black
At layer #6 (0.64mm) swap to Space Blue
At layer #10 (0.96mm) swap to Red
At layer #15 (1.36mm) swap to Yellow
At layer #22 (1.92mm) swap to Grey
At layer #28 (2.4mm) swap to Ivory White for the rest.