If you have a tripod or light stand that has the little 1/4" screw on it, and you want to put something that takes the bigger 3/8" 16, then this is what you need.

You may need the opposite adapter. I have you covered. Find it here.

Print this with your most robust filament for the best layer adhesion. I used PETG, which is very strong. My profile is set up for strength.

That's it. I cannot think of much more to say.

As always, I would appreciate a 'like' if you find this helpful. Also, could you rate the profile? It doesn't cost anything, but it makes this big old fella happy.