GPU Simple Sag Support Bracket

Copyright Claim

GPU Simple Sag Support Bracket

Boost
8
11
8

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.2mm layer, 3 walls, 30% infill
0.2mm layer, 3 walls, 30% infill
Designer
1.1 h
1 plate
4.4(5)

Open in Bambu Studio
Boost
8
11
8
3
74
48
Released

Description

This two piece print uses a screw to adjust height anywhere from a 90mm to 55mm gap between the GPU shroud and the case.

 

A few printers have expressed that the threads are tight. Be aware, depending on your print settings, you may want to add an extra off set to either piece for a better fit.

Comment & Rating (8)

Please fill in your opinion
(0/5000)

Terrible print. Wouldn't screw in initially, then after some light sanding and dish soap, it did start. I got it about halfway screwed in (using a 10" wrench), almost to where I needed it, and then it seized. I couldn't budge it after that; it wouldn't loosen or tighten. It was a waste of time and filament.
The designer has replied
0
Reply
Sorry to hear this print did not work for you. I wouldn’t recommend using dish soap and a wrench to assemble this print however I can suggest taking a look at your flow and tolerance settings used in Bambu studio. thanks for the feedback!
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Had to slightly reduce scale to fit me use and it was very hard to tighten after a while
0
Reply
its working :¨)
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
A superb way to keep your GPU from sagging! #stopthesag!
Show original
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 30% infill
0
Reply
No more